Main Page Sitemap

Last news

"Chocobo's Mysterious Dungeon Coi Vanni Gialli".A b "Final Fantasy viii"."Chocobo's Mysterious Dungeon 2 OST". "Chocobo's Mysterious Dungeon OST".A b Goto, Shoko.A b "Show Case NTT D505iS" chocobo (in Japanese).These games chocobo include chocobo installments of the."Final Fantasy Fables: Chocobo's Mystery chocobo Dungeon Every Buddy Announced For Switch And..
Read more
It consolidates all the business expenses that driver you will incur for business drives. Correct errors before theyre caught during an inspection.Some of the features books on the KeepTruckin Electronic Logbook app include: Electronic Logging Devices photo (ELD) compliance It makes vehicle inspections easier It monitors fuel usage..
Read more

Trane z wave thermostat installation manual





Pay special installation attention to installation steps 3, 3a, and.
The CA8900 operates as a thermostat wave simple thermostat with buttons to set target temperatures for heat and cool modes.
3 4 L Y1 Y2 Rc R Rh R X2 T W1 W2 W3 516-001 Rev.
trane Inclusion 4, exclusion 4, inclusion and Exclusion 4, operation Thermostat Control Buttons 5, lEDs 5, thermostat Screens 5, thermostat Control Screen.Change Over Valve Orange (brown y2, compressor stage 2 Black * if you have a terminal marked B with a brown wire attached to it, that means you have a changeover (C/O) with heating type heat pump system.Remove all screws attaching the wall plate to the wall and remove wall plate.Caution: equipment damage hazard - Improper wiring can lead to equipment damage.Also, the thermostat is not compatible with dual fuel systems (gas furnace heat pump combined) without adding a special kit.03/09-a 2Y 1 c R Rh 3W 2W 1W T 2X 5 Remove existing wall plate.Refer to: Chart 1 - If you do NOT have a heat pump Chart 2 - If you have a heat pump.If the number listed there is 000, thermostat the thermostat has NOT been successfully enrolled.If you have a W terminal, use the W1 label on that wire.Each module in a, z-Wave network communi- cates with every other mod- ule, acting as a repeater and routing manual your commands to their trane destination by the most reliable pathway. If the thermostat display does not come on, go back through the installation steps and look for problems.
Description maintenance and Features, this guide is in two parts: Part One: Operating Guide for the homeowner or serial end user.
Use 1/8 blade screwdriver to secure wires in terminals.
Follow the System Type table carefully to properly select and setup serial the control to ensure proper heating and cooling system operation.
It cannot be used with line voltage systems.
Do NOT cut JP1 jumper Cut JP1 jumper If only one wire is connected to either 24RC or 24RH as shown If wires are connected to both 24RC and 24RH as shown 8 17 If your tiger System Type is: Gas manual Furnace - Single Stage,.
Verify that the outdoor unit and the system fan come on and run.Do not use wire colors to chose labels.Standard hvac System Wiring, terminal, meaning, marking.The thermostat is compatible with all standard 24 VAC heating and cooling systems, up totwo-stageheat, one-stagecool, andtwo-stageheat pump.This will enable you honda to add your Smart service Thermostat device to the Home Control Network.Test Cooling Operation (if your system has cooling).Standard hvac System Wiring, terminal, marking, meaning Typical Wire Color Record the old thermostat wire connections and terminal marking here.Scroll up or down to Set Clock (it is the rst option then press the Select button.Connect a 24 VAC common wire to power the thermostat.Scroll up or down ( or -) to make changes.Be sure to set the change over type in the Installer Settings menu anniversary to C/O Type: w/Heat.TheZ-Waveicon shows on the lower right of the display panel, indicating that the thermostat is in contact with the controller.Some wire terminals may not be used Some wire terminals may not be used 13 If necessary, cut the internal jumper wire (JP1).P516-393 3A 2, if you are unsure about connecting this wire or you do not have any unused wires at the thermostat, contact Customer Service.



Locate the wiring labels located in the box with the new thermostat.
Standard gas/oil/electric heating systems o o, trane z wave thermostat installation manual heat Pump systems: o o o, do NOT use for line voltage controls (120/240VAC).

Sitemap